Tool Kits Help Rolling Bearing Work

Two products that help to speed up and simplify the mounting and dismounting of rolling bearings are available from Schaeffer (UK). Both will help prevent unnecessary damage when mounting rolling bearings and will increase worker safety on site. The Fag rolling bearing mounting tool kit provides quick, precise and safe mounting for small bearings with bore diameters from 10 to 50mm. Where tight fitting inner or outer rings are to be driven onto a shaft or into a housing bore, hammer blows can be applied to an appropriate mounting sleeve with a mounting ring. The right combination of mounting sleeve and mounting ring ensures that the mounting forces are never transmitted via the rolling elements of the bearing, while guaranteeing an even transmission of mounting forces to the bearings rings. The Fitting Tool Alu Set 10-50 is easy to use and can be used to mount a wide variety of rolling bearings. The tool kit contains 33 mounting rings of shock-resistant plastic, three mounting sleeves of a special design and one recoilless hammer with an anti-slip handle. This tool can also be used with workshop power presses and can be operated by one person. The Puller Internal Set 10-100 lets fitters dismount deep groove ball bearings in most cases without having to dismount the shaft as well. Consisting of six sets of extraction arms and two threaded spindles made of high grade steel, it is suitable for deep groove ball bearings with bore diameters from 10 to 100mm. The Puller Internal set is also easy to use and as it is lightweight only one person needs to be involved in the dismounting process. It comes with a practical tool case for safe and convenient storage.